Black screen on windows setup laptop DELL latitude e6410 solved

Start button, seen the dell logo...after that, black screen with a flashing cursor.

I've tried to startup again and reinstall windows from my CD, after a few minutes appears the stop error blue screen:

"A problem has been detected and windows has been shut down to prevent damage to your computer. If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps: check for viruses on your computer. Remove any newly installed hard drives or hard controllers. Check yur hard drive to make sure it is properly configured and terminated. Run CHKDSK / F to check for hard drive corruption, and then restart your computer. Technical information; 

***STOP: 0X0000007B (0XF78D663C, 0XC0000034, 0X00000000, 0X00000000)"

Did a little research, and found that eSATA and SATA on same controller requires AHCI or IRRT enabled in the BIOS under "SATA Operation", but that changing this mode from ATA to AHCI would likely cause windows to blue screen on boot.

Tried again, start laptop, hit F12 to enter Setup Bios, under System Configuration and SATA Operation, i've changed the initial bios configuration for eSATA controllers, and  i finally managed to intall windows.

My Initial Bios SATA Operation configuration that showed the blue screen error was RAID On and after changed SATA Operation from RAID On to ATA, i've booted and succesfully installed windows.